Repair & Restoration
Hardwood Floor Repair in Logan Square, Philadelphia
Board replacement, weaving in new wood, squeaks, gaps and cupping. In Logan Square, Philadelphia the median home dates to 1972 and 19.7% of the housing predates 1940, which changes what Deco Hardwood Floor expects to find before the work starts.
The repairs a postwar oak floor usually needs
In Logan Square repair is most often squeaks, stained boards found under old carpet, and damage at the doorways where rooms were once divided.
Squeaks come from movement between the boards and the subfloor, and they are fixed with fasteners into the framing, not with powder or filler. Stained or damaged boards are cut out and replaced, and in this stock that is the easy part: two and a quarter inch red oak is still a standard board.
The replaced boards are laced into the floor in a staggered pattern, so there is no straight line where the repair begins and ends.
Before you get a quote
Fresh oak is lighter than oak that has aged for sixty years. After sanding and finishing the two are close, and they keep getting closer as the new wood takes light.
How the housing in Logan Square compares
Of the 13,597 housing units in Logan Square, roughly 2,700 were built before 1940 and approximately 7,700 before 1978.
That makes the housing here newer than the 132 Philadelphia neighborhoods in our data taken together, where approximately 82.8% of 733,961 units predate 1978, and below the 60.5% figure for our whole service area. By the share built before 1940, Logan Square ranks 101st of those 132. The full table is published as open housing data.
Within Philadelphia, the oldest housing in our data is in Cedar Park, with a median year of 1925, and the newest is in Kensington, Old, at 1997.
| Place | Median year built | Built before 1940 |
|---|---|---|
| Logan Square | 1972 | 19.7% |
| Rittenhouse | 1951 | 43.9% |
| Spring Garden | 1962 | 38.8% |
| Francisville | 1937 | 52.9% |
| Fitler Square | 1929 | 67.1% |
| Center City East | 1982 | 41.1% |
| Chinatown | 1974 | 20.3% |
For repairs, the median year tells you what has to be matched. Older floors need narrow boards from denser timber, and newer ones need a factory color that may no longer be made.
What is usually under the floor here
Two and a quarter inch red oak nailed over a wood subfloor, which is the case that refinishes best.
Postwar housing in this region was built with a plywood or board subfloor and solid red oak strip on top, most commonly two and a quarter inches wide. It is the standard floor of the American postwar house and it is the easiest thing we work on: predictable thickness, predictable fastening, predictable result.
The question in this stock is more often the subfloor than the wood on top of it. Squeaks, deflection and movement come from below, and sanding a floor that moves gives you a smooth floor that still moves.
Worth knowing here
Red oak has a pink undertone that shows through most stain colors. If you are aiming for the cooler tones that are fashionable now, that gets tested on a sample board before anything is committed.
Whether the federal lead rule applies depends on the house
Approximately 56.4% of the homes here predate 1978, so it comes down to the specific address.
This is a place where the housing stock straddles the 1978 line the EPA rule draws. Roughly half the addresses are covered and roughly half are not, which means the answer is per house rather than per town.
Where it does apply, the rule governs how the sander is set up: containment and a HEPA vacuum collecting dust where it is generated. We check the age of the house before deciding how the work is staged.
How hardwood floor repair runs
We find the cause
Moisture readings, and a look underneath where access allows.Damaged boards cut out
Removed without disturbing the sound wood around them.New boards woven in
Staggered joints, matched species and thickness.Fastened and levelled
Flush with the surrounding floor, because a proud board catches every time.Finished
Blended into the surrounding area, or the room refinished where that is what makes it disappear.
What does a hardwood floor repair include?
A repair includes finding the cause, removing the damaged boards, weaving in new ones of the same species and thickness, fastening them flush and finishing the area. We supply the wood together with the labor.
Included
- An in-person estimate from the owner, with moisture readings on the surrounding boards
- A look at the subfloor from below, wherever a basement or crawl space gives access
- Removal of the damaged boards without disturbing the sound wood around them
- New boards matched in species, width and thickness, supplied with the labor
- Joints staggered into the existing floor so no straight seam is left
- Sanding and finishing of the repaired area, blended into the floor around it
Not included, or quoted separately
- Plumbing, roofing or any other work to stop the leak that caused the damage
- Framing or joist repair, if the movement turns out to be structural
- Refinishing the whole room, which is often recommended and is quoted as its own line
- A promise that the repair is invisible on day one beside an old finish
What changes the price of a hardwood floor repair?
The price is set after we see the floor, because the visible damage is rarely the whole job. What moves it most is how many boards come out, whether the subfloor is involved, and how much refinishing it takes for the repair to blend.
| What changes it | How it moves the price | Example |
|---|---|---|
| Number of boards replaced | More boards mean more material and more cutting. Weaving adds to the count, because the neighboring boards are cut back too. | A few stained boards at a dishwasher become a wider area once the joints are staggered into the floor. |
| Access from below | An open basement ceiling lets us inspect and fasten from underneath. A finished ceiling means working only from the top. | A squeak over an unfinished basement is a simpler job than the same squeak over a finished ceiling. |
| Species and board width | Common red and white oak strip is easy to source. Old widths, old pine or an unusual species take a search or custom milling. | A wide pine board in an old row house costs more to match than oak strip in a later house. |
| Subfloor condition | A soft, wet or moving subfloor has to be dealt with before new boards go down, and it is only fully visible once the floor is open. | Boards at an old leak come up and the plank subfloor under them is dark and soft. |
| How far the finish goes | Blending a small area costs less than refinishing the room, but a large or central repair may only disappear with the whole room done. | A repair near a wall can be blended locally. One in the middle of a living room usually cannot. |
The full method, the equipment and what we will and will not promise are on the service page: Hardwood Floor Repair.
Also in Logan Square
Hardwood Floor Refinishing
Sand the old finish off, repair what needs repairing, and put a new finish down
Dustless Floor Sanding
Vacuum-extraction sanding
Solid Hardwood Floor Installation
Solid wood, nailed down over a wood subfloor
Engineered Hardwood Installation
Real wood over a stable core
Luxury Vinyl Plank (LVP) Installation
Waterproof, quiet, and it does not care about a wet basement
Custom Stair Installation
Treads, risers, stringers and skirt board, built to a drawing instead of a catalog page
Stair Refinishing
Stairs take more wear per square foot than any floor in the house, and they are sanded almost entirely by hand
Why homeowners hire Deco Hardwood Floor
Deco Hardwood Floor is owner operated: the person who quotes hardwood floor repair in Logan Square is the person responsible for it, and the material comes with the labor in one number.
Material and labor in one number
We buy the flooring direct from the distributor and pass the store price through, so you are not sourcing wood on your own between quotes.
Samples come to your house
Samples and larger offcuts come to you, so the color gets chosen in your own light instead of under a showroom lamp.
Stairs and railings built in house
Treads, risers, handrails and newel posts are drawn and built by our own crew. Most flooring crews subcontract stair work or decline it.
The owner quotes the job
The person who measures your floor is the person responsible for the work. There is no salesperson in between.
Measured before it is promised
Remaining thickness is measured at the edge of a board before we say a floor can be sanded, and no price is firm before we have seen the room.
Told straight, including the limits
Vacuum extraction catches most of the sanding dust and not all of it. We tell you that before the job instead of after.
More about who we are and what we will not claim on the About Deco Hardwood Floor page.
Questions about floor repair in Logan Square
Can I stay in the house while the floor is being repaired?
Yes, in most cases. A hardwood floor repair is confined to one area, so the rest of the house stays in use. The room being worked on is closed off while boards are cut and sanded, and it stays off limits until the finish has dried enough to walk on. Vacuum extraction on the sander catches most of the dust, not all of it. Keep pets and children out of that room.
What should I do before the crew arrives for a floor repair?
Stop the cause first. If a leak damaged the boards, have it fixed and tell us when it happened. Then clear the area of furniture, rugs and anything fragile. Before a hardwood floor repair it also helps to look in the basement or the attic for boards left over from the original installation, because those are the closest match there is.
Can you repair just one board?
Often yes. The limit is usually access and matching rather than the carpentry, and a single board in the middle of a room is more visible than the same repair near a wall.
My floor squeaks. Can that be repaired?
Usually. Squeaks come from movement between the floor and the subfloor, and the fix depends on whether we can reach the underside. From above there are fastening methods that work; from below there are better ones.
Can you tell me what my floor needs over the phone?
We can tell you what is likely, and this page is most of that answer. What we cannot do is quote a floor we have not seen, because remaining thickness and what is under the covering both decide the job and neither is visible in a description.
Do you bring the material?
Yes. We buy direct from the distributor and the material lands in the same number as the labor. Samples and larger offcuts come to the house so you choose in your own light.
My floor squeaks. Will refinishing fix it?
No. Squeaks come from movement between the floor and the subfloor, and sanding the surface does not change what is happening underneath. Those get addressed before the floor is finished, not after.
Floor Repair near Logan Square
Send a photo and we will tell you what you are looking at
Hardwood Floor Repair in Logan Square starts with someone reading the house. We quote every job ourselves, with no salesperson in between, and a photo of the floor gets you a straight answer faster than a form does.
