Deco Hardwood FloorDeco Hardwood Floor Get an estimate

Service area

Wood Floors in Delaware, NJ

We sand, refinish, install and rebuild wood floors and stairs in Delaware, NJ. The median home here dates to 1980, and 22.2% of the housing was built before 1940, which is what decides whether your floor is a refinish or a restoration.

Wood stair treads with a horizontal steel railing
County
Hunterdon County, NJ
From our base
26.8 miles
Population
4,563
Housing units
1,853
Median year built
1980
Built before 1940
22.2%
Built before 1978
approximately 47.5%
Owner occupied
91.7%

What is usually under the floor here

Prefinished solid or engineered wood, and whether it can be sanded at all depends on the wear layer.

Housing from the 1980s and 1990s brought factory-finished floors and engineered construction into the mainstream. Both look like wood because they are wood, and both behave differently under a sander than the site-finished floors that came before.

Engineered flooring has a real wood layer over a plywood core, and that layer can be anything from a generous four millimetres to under two. Under two, sanding is not on the table. This gets measured, not assumed, and the answer decides whether the conversation is about refinishing or about replacement.

Worth knowing here

Factory finishes are usually aluminium oxide, which is harder than anything applied on site. It does not accept a new coat without proper abrasion, and skipping that step is why recoats peel.

Whether the federal lead rule applies depends on the house

Approximately 47.5% of the homes here predate 1978, so it comes down to the specific address.

This is a place where the housing stock straddles the 1978 line the EPA rule draws. Roughly half the addresses are covered and roughly half are not, which means the answer is per house rather than per town.

Where it does apply, the rule governs how the sander is set up: containment and a HEPA vacuum collecting dust where it is generated. We check the age of the house before deciding how the work is staged.

Long window shadows falling across pale wood planks

What the work here usually looks like

Housing values here sit in the top quarter of our service area, and the majority of homes are owner occupied. In practice that means bigger floors, more wide plank and more custom stair work than the regional average.

New Jersey runs its own registration through the Division of Consumer Affairs, and it is not interchangeable with Pennsylvania's. The number begins with the prefix 13VH. How contractor registration works in New Jersey →

What we do in Delaware

Questions

Do you actually work in Delaware?

Yes. Delaware sits 26.8 miles from our base in Philadelphia, inside the area we cover. We quote the job before we schedule it, so you know the answer before anyone commits.

Can you tell me what my floor needs over the phone?

We can tell you what is likely, and this page is most of that answer. What we cannot do is quote a floor we have not seen, because remaining thickness and what is under the covering both decide the job and neither is visible in a description.

Do you bring the material?

Yes. We buy direct from the distributor and the material lands in the same number as the labor. Samples and larger offcuts come to the house so you choose in your own light.

How do I know if my engineered floor can be refinished?

By measuring the wear layer, which is the real wood on top of the core. Above about three millimetres there is room to work. Below two there is not, and no amount of care changes that.

Towns near here

Send a photo and we will tell you what you are looking at

Wood floor work in Delaware starts with someone reading the house. We quote every job ourselves, with no salesperson in between, and a photo of the floor gets you a straight answer faster than a form does.

Inside Trafego Pago
Call (267) 322-2345